CPSMAME

kenfire · Post by **kenfire** » Sat Nov 16, 2002 4:31 pm

I was wondering which games this emu supports. Also I used Piony's scrambler which converted the elf file to 1ST-READ_bin but was wondering how or where to get the IP_bin for it.

clessoulis · Post by **clessoulis** » Sat Nov 16, 2002 5:01 pm

use the one from feet of fury or DreamSnes plain files.

Nyarlathotep · Post by **Nyarlathotep** » Sun Nov 17, 2002 10:20 am

clessoulis wrote:use the one from feet of fury or DreamSnes plain files.

Do NOT use the ip.bin from DreamSNES unless you want to make a coaster - the DreamSNES ip.bin points towards a file called 1dsnes.sh4 *NOT* 1st_read.bin.

Bad help is worse than no help at all

Nester, SMEG, DCDivX, almost all non WinCE programs will have an ip.bin pointing to 1st_read.bin, which is what you need - just download whichevers smallest if I were you

I repeat: DreamSNES's ip.bin *will not work*

kenfire · Post by **kenfire** » Sun Nov 17, 2002 1:17 pm

hey thanks Nyarlathoep for the information and help.

clessoulis · Post by **clessoulis** » Sun Nov 17, 2002 1:23 pm

Nyarlathotep wrote:
clessoulis wrote:use the one from feet of fury or DreamSnes plain files.
Do NOT use the ip.bin from DreamSNES unless you want to make a coaster - the DreamSNES ip.bin points towards a file called 1dsnes.sh4 *NOT* 1st_read.bin.

Bad help is worse than no help at all

Nester, SMEG, DCDivX, almost all non WinCE programs will have an ip.bin pointing to 1st_read.bin, which is what you need - just download whichevers smallest if I were you

I repeat: DreamSNES's ip.bin *will not work*

Sorry my bad. I just use the one from nesterdc most of the time.

NoahsMyBro · Post by **NoahsMyBro** » Tue Nov 19, 2002 8:39 am

I'm new to this, and just want to make sure I understand what to do here:

* I want to run MAME on my Dreamcast.

* I downloaded the plain files CPMAME, and the Piony's scrambler.

* I used the scrambler program and converted the .elf to a .bin.

* I then burned the .bin to a CD. On the same CD, I burned a directory called samples, and a directory called ROMS, along with the samples and roms in the respective directories.

* I then boot the DC with Utopia 1.1, and once it's loaded I put in my burned CPMAME cd.

* The LOADING message appears and counts to 98%, and never goes any further.

Based on what I've read, I think I need to find an IP.BIN file, and burn it to the CD as well. Is that correct?

Thanks,
Steve