The required file was not found! KOS

If you have any questions on programming, this is the place to ask them, whether you're a newbie or an experienced programmer. Discussion on programming in general is also welcome. We will help you with programming homework, but we will not do your work for you! Any porting requests must be made in Developmental Ideas.
Post Reply
DCEmu Newbie
DCEmu Newbie
Posts: 1
Joined: Tue Nov 17, 2020 9:49 am
Has liked: 0
Been liked: 0

The required file was not found! KOS

Post by Sjors » Tue Nov 17, 2020 9:52 am

Hello! I am getting started with DC development.
When running the install script, or the manual steps for installing KOS as per the wiki, the following occurs in

Code: Select all

Code: Select all

The required file was not found!
I'm not sure where this config file is supposed to come from.
This is on MacOS Catalina.
Can someone please point me in the right direction?
User avatar
The Crabby Overlord
The Crabby Overlord
Posts: 5447
Joined: Mon May 27, 2002 11:31 am
Location: Sailing the Skies of Arcadia
Has liked: 3 times
Been liked: 24 times

Re: The required file was not found! KOS

Post by BlueCrab » Tue Nov 17, 2020 10:25 am

The dc-chain setup has changed a bit recently. Please take a look at the file in that directory for more information on setting up the file.

Long story short, there's a couple of templates there in the same directory ( and Pick the one that you'd like to use, modify anything in it to fit your environment if needed, and rename it Then it should "just work".
Post Reply